support@homewaterfilters.com.au

07 5221 5538

Omnipure Fluoride Removal Cartridge XF934, 5 Micron, 10 x 2.5 Inch

Omnipure Fluoride Removal Cartridge XF934, 5 Micron, 10 x 2.5 Inch

$104.00 inc GST

The Omnipure Fluoride Removal cartridge is your solution for clean, safe drinking water. This high-performance filter effectively removes more than >90% of fluoride from your water supply, Suitable for countertop and undersink water filters.

  • Removes fluoride >90 and fine sediment
  • Micron: 5 micron
  • Certified to NSF/ANSI 42 for material safety
  • Manufactured in USA by Omnipure (10 Inch Part Numbers XF934, FL051, As001A10)
  • Drop-In cartridge for ease of replacement

 

Specifications:

Size:                                    10″ x 2.5″
Max. flow rate:               3.8 litre per minute
Filter output:                  1,900 litres or 6-12 months
Water Temperature:   +2°C to +38°C

 

Please Note: when changing the fluoride cartridge it is important that the fluoride cartridge is flushed alone to prevent it from flushing into the next stages of filtration.  Flush water through this cartridge in the system for 20 minutes before adding the next stages. View Instructions.

 

 

SKU : IT001471-1 Categories : ,

How to Install and Flush the Fluoride Removal Replacement Cartridge

Follow these crucial steps to ensure optimal performance and the best-tasting filtered water: 

  1. Unpack the new fluoride replacement cartridge.
  2. Connect it to your water filter system, but don’t turn on the water yet.
  3. Remove all filtration cartridges that come after the fluoride removal cartridge (typically in position 1 or 2). Handle the ceramic cartridge with care, as if it were an egg.
  4. Install only the fluoride removal cartridge, then turn on the water and check for leaks.
  5. Flush the system for 20 minutes with only the fluoride cartridge installed. If desired, you can collect this water for plants.
  6. Turn off the water supply and open the faucet to release pressure and drain.
  7. Reinstall the other cartridges in their original positions.
  8. Tighten all housings and turn the water supply back on. Check for leaks.
  9. Flush the entire system for 10 minutes.
  10. After 12 hours, flush the system again for 3 minutes. 

    Your water filter is now ready for use.

Performance Data Sheet

Download Data Sheet

Related products

Home Water Filters Australia Logo
07 5221 5538